4 stuks Ecler XPA5000 te koop: 3 in goede staat, 1 met een defect kanaal.
Biedingen zijn per stuk!

With a rack power amplifier, the speaker load and operating mode must suit the PA system. The Ecler XPA-5000 is a two-channel MOSFET power amplifier with a rated output of 498 WRMS per channel at 4 ohms. Stereo, parallel and bridge modes allow it to be used with different speaker configurations; in bridge mode, the load must not fall below 4 ohms.
Balanced XLR and 6.3 mm jack inputs are available for signal connections. The input sensitivity can be set on the rear to 0.775, 1 or 1.4 V; the input controls on the front allow separate level adjustment. The supplied transparent caps let you protect the control settings from being changed accidentally while keeping them visible. The controls can be secured against tampering – the GND-LINK switch can also disconnect the electrical and mechanical ground connection.
The integrated ANTICLIP limiter is always active. If the signal level is too high, it reduces the input level and only intervenes once distortion reaches the threshold. If required, you can activate the switchable subsonic filter using the rear-panel switch: it operates at 30 Hz with a slope of 18 dB per octave and reduces very low-frequency content that could cause unnecessary woofer excursion. The limiter and switchable subsonic filter work together to protect the power amplifier and speakers.
Protection also includes circuitry against short circuits, overheating and DC voltage at the output. The indicators show signal presence, clipping and activated protection circuits. A continuously lit PROT indicator signals a fault; when the amplifier is switched on, it initially lights during the stabilisation period of around ten seconds. SP, CLIP and PROT indicators make it easier to monitor the signal and operating status.
The cooling system draws air into the unit at the rear and expels the warmed air at the front. Airflow increases with temperature. A clear ventilation path is therefore important when installing the amplifier in a rack. The 19-inch enclosure occupies two rack units and has an aluminium front panel. Air flows from back to front, which should be taken into account when positioning it alongside other equipment.
You can connect the speakers via Speakon sockets or screw terminals. In bridge mode, the input signal is fed into Channel 1; the bridge output is available at Speakon contacts 2+ and 2− or at the red screw terminals. Contacts 1+ and 1− are used for stereo and parallel modes. Speakon and screw terminals provide two connection options for speaker wiring.
With peak output power of up to 1,050 WRMS at 2 ohms in stereo mode and 996 WRMS at 8 ohms in bridge mode, this model supports several common load configurations. The XPA-5000 is therefore suited to rack setups for PA systems that require two channels, selectable operating modes and flexible speaker connections. Load impedance and operating mode are the key criteria for choosing the right configuration.